Aspects of Photovoltaic Systems: Study and Simulation of Silicon Phthalocyanine Bulk Heterojunction Solar Cells and Monochromatic Photonic Power Converters

Abstract

This thesis discusses two different photovoltaic systems, organic solar cells, and photonic power converters. The open-source software package Solcore was used to simulate and analyze optoelectronic properties of both systems. It is widely accepted that the transition from a fossil-fuel driven economy is necessary in the coming future. Organic solar cells are an alternative energy generation method with potential for fast energetic and economic payback periods. Bulk heterojunction organic solar cells are a common design, as they have particularly low manufacturing costs due to a simple device architecture. In this work, two bulk heterojunction blends are experimentally assessed using the acceptor molecule silicon phthalocyanine (bis(tri-n-butyl silyl oxide) silicon phthalocyanine ((3BS)2-SiPc) as a potential low-cost non-fullerene alternative to the typical acceptor [6,6]-phenyl-C61-butyric acid methyl ester (PC₆₁BM). These acceptors are compared within blends with the typical donor compound poly(3-hexylthiophene) (P3HT), and also poly[(2,6-(4,8-bis(5-(2-ethylhexyl)thiophen-2-yl)-benzo [1,2-b:4,5-b’]dithiophene))-alt-(5,5-(1′,3′-di-2- thienyl-5′,7′-bis(2-ethylhexyl)benzo[1′,2′-c:4′,5′-c’]dithiophene-4,8-dione)] (PBDB-T). Device performance was assessed under standard conditions, increased angles of incidence, and reduced light intensities. Devices with the P3HT:(3BS)2-SiPc blend achieved a power conversion efficiency (PCE) of 3.6%, which outperformed P3HT:PC₆₁BM devices with a PCE of 3.0% due to a higher open-circuit voltage (VOC) of 0.76 V as opposed to 0.53 V. The PBDB-T:(3BS)2-SiPc achieved a high VOC of 1.09 V, but had a lower PCE of 3.4% in relation to the PBDB-T:PC₆₁BM device with a PCE of 6.4% and a VOC of 0.78 V. Photonic power converters are devices in optical networks that allow for optical power transmission rather than the conventional method of electrical power transmission. This provides benefits such as electrical isolation and resistance to electromagnetic interference, along with the ability to propagate along the same cable as data. These power converters are used to convert optical power to electrical power, and operate similarly to a solar cell with a narrow bandwidth. Multijunction designs are often used for increased operating voltage and efficiency. In such designs employing a vertical architecture, the bottom-most junction has the largest thickness along with the lowest efficiency due to increased recombination losses. To improve this lower efficiency, light trapping techniques can be employed to decrease the junction thickness while retaining the optical thickness. In this work, a current-matched 5- junction GaAs photonic power converter was simulated with both metallic and distributed Bragg reflectors at the rear of the device. These reflectors allowed for the thinning of the bottommost junction, which resulted in an increase in efficiency and overall power output of the power converter.